When I press "f" there is a slight pause. And "f" "enter" the same.
But no difference with or without the "f". But it looks like the wifi board sees the input.
I appreciate your help. But for now I have given up until sometime. :)
This is amazing stuff, even for the older Phantom2. And to...
Hello @quaddamage
I followed your links and then also ended up at OpenWrt Project: Serial Console where they give good instructions on how to identify the Router Serial Connector Ports/Points "UART" port. Thank you for the lead. It is just what I needed to get this started. There is...
Hello Quaddamage
Thank you for helping. I am looking now, and it seems there is a similar way to write OpenWrt back to the board via a Ft232 adapter. I must just connect the correct tx/rx ports on the board and then figure out the rest.
The commands I used was from a post Install OpenWRT WebUI...
Hello @quaddamage , I hope you dont mind me asking. I have been reading many pages where you give advice on other topics, and you seem to have more advanced knowledge on this kind of problem.
Do you mind telling me what you think of this, and if it is something this drone could recover from...
Hello Phantom Pilots
I have had great success following instructions from @linuxkidd to install OpenWRT Luci to the RE700 Range Extender. This allowed me to access the web UI. It worked great and I learned a bunch of things.
Then following the same instructions, I wanted to install Luci to my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.