would using a RP-SMA Female to SMA Male adapter" between the FPVLR 90 degrees RP-SMA Male Antenna and the ImmersionRC 600mW VTX noticably degrade performance?
With the Anti-inferference board now mounted on top of the iOSD Mini should I look into replacing all of the cables going into the FPV Hub that may have been stressed from all of this fiddling around?
I will have to wait to check on the sound of the phantom 2 and also look at the gimbal to see if it's wobbly. which gain settings do you recommend adjusting? I have modified the gain for the Gimbal Tilt Control. Brought it way down, but that's all that I touched in terms of gain settings
Hello, after replacing my AVL58 with Cloverleafs with an ImmersoinRC 600mW (stock antenna) and a Black Pearl 7-channel (stock antennas) I am seeing a significant amount of Jello.
Here is the previous layout where I had the anti-interference board on top of the AVL58
I replaced the AVL58...
with this Plug and Play Cable the IRC 600mW Transmitter interfaces with the iOSD Mini instead of plugging into the VTX port of the FPV Hub? I am considering upgrading from the AVL58 to the IRC 600mW and was looking for a simple no-soldering solution.
GoPro Hero3+ Black, and i used GoPro Studio (High Quality conversion, and removed Fisheye) to export to CineForm AVI and then I converted to a final render using x264 10-bit 4:2:0 35 Mbps bit rate