Recent content by Emmbee

Thanks for the response- I'll give it a try

hi, I was flying last night , usual spot (very rural) 2000 ft distant and 190 ft altitude when suddenly the mode changed to P-OPTI then into ATTI back into P-OPTI plus I had warning 'satellite poisoning off , fly with caution' - then back to P-GPS. This all happened in a matter of seconds...

Sounds good, I'll give it s go....

I thought I'd waited long enough, so finally upgraded to 3.12 - now cannot calibrate the compass however much I dance ! Any ideas, or anyone had similar ? Thanks Mark

Thanks for your help Mark

Hi Thanks for the replies, is the general consensus then that loctite is not required, for example after opening shell to do the foil mod ? Mark

Hi, What type of loctite is suitable for use on phantom, where it's a screw to plastic connection.. Thanks Mark

Love the new features, however I can only get the Wand to work on iPhone 6, and doesn't work on iPad wifi only. Is this right ! Thanks Mark

Morning, Are these suitable phamtom 2 plus ? Thanks Mark

Tonight, when systems turned on but propellers not spinning, the altitude read -42 ft. This time I waited and waited and within about 10 minutes the altitude display gradually showed more or less the correct level. Turned all off and tried again, same result - do I have a very slow reacting...

Thanks for your informative and helpful comments. Much appreciated.

Thanks again, Just tested again. Display fluctuates between -35 to -45 whilst stationary with motors off. Couldn't test fly - too windy in this part of the UK

Thanks for the response. Just tried compass calibration - same result. Good home lock as verified by second set of green flashes/distance shows zero/H shows in ground station/symbols and figures are blue / ten sats. Hmmmm....

Hi, Another newbie needing help. Altitude display in app shows anything from -20 to -50 ft whilst at ground level before take off. When in flight it sometimes, but not always corrects itself to what I consider to be about right. Have done advanced calibration twice, with no results -...