Recent content by Elmtreepete

  1. E

    Phantom 1 & new Tx

    Hi- i'm assuming as the new tx is binding to the aircraft rx, it must be correct! The aircraft rx is still the original.
  2. E

    Phantom 1 & new Tx

    Hi all - although I have a Mavic pro, i am looking to get my Phantom 1 back in use too. I have managed to get a replacement Tx for it, as one of the stick gimbals on the original unit failed (Bought the Phantom in 2013). I can confirm that I have bound the new Tx to the receiver ok, I've done...
  3. E

    Programming Futaba 18SZ with Phantom1

    Hi all, I know it's new, but anyone tried using an 18SZ and s-bus receiver on the Phantom 1? My original stock DJI tx has packed-up, and want to use my 18SZ, which does have 'Multicopter' model type as type of model. Would welcome any comments re setting it up. Thanks
  4. E

    Mode 1 conversion

    I've just received my Phantom which has come with the newer Tx with both sticks spring to centre and I assume is set for mode 2. I fly mode 1 and again assume I would just swap the two left-hand (un-marked) stick gimbal plugs around inside on the PCB, and re-calibrate? DJI tutorial site only...