I have a Advanced Gimbal and 2.7k Camera from my P3A, had 2 flights, rough landing caused the yaw arm to break and tear the cable, I replaced both and still had a life less gimbal. Only exterior damage was a small ding on the camera body from impact. After some research I found a few people who...
I also recently purchased fstop labs ribbon cable and yaw arm replacement after a crash and after its all said and done. I now have no power to any part of my gimbal and getting numerous errors. Was told I may have a damaged circuit board but now seeing this. It may be a bad ribbon. It did not...
I recently crashed my Phantom 3 advanced, broke the yaw arm and ribbon cable. Both were replaced and everything inside appeared to be ok. Upon turning drone on, it gives me 4 errors on the app.
1st- top of app says no image transmission signal
2nd-aircraft requires firmware upgrade
3rd-battery...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.