Recent content by doug6653

i think its "foooked" as they say. i think there is more than one problem with it. i have access ito the phantom 3 advanced, but dont think that would help.

camera is just going wild, battering from stop to stop on every motor, which are getting extremely hot still saying gimble not active and no picture from camera. rotors not starting either

ok thanks for that. its sitting off the flat spot just now

dont understand what the set screw and flat spot you are talking about are

thanks for the reply brad just tried it again. this time the camera is spinning about wildly and motors are heating up and i canr get it to stop. at the same time, the start routine for the motors isnt functioning cant see anything else loose or broken on the main board either

I bought and fitted one of these from the same supplier. This was after a crash which ripped the ribon cable mount off of the board. the camera still dosent activate. controls for motors seem a bit sporradic too. app says "gimbal dissconnected" most of the time. any ideas what i should be...