That's cool I changed the settings in the rc tab and didn't write the original ones down would you mind looking and tell me what there set to???? Thanks... I changed to x still doing the Funkey chicken hoping this helps...thanks again..
About frustrated with my taco.... Any help would be greatly appreciated... I attached a vid with my settings .. Thanks....:(
http://youtu.be/kr70YoS2R74
When I used my sd card to upgrade the camera firmware I had a similar issue. The sd card was formatted in the phantom app for that. Afterwards I could only see vids thru app. To fix I reformatted the card on my PC u will lose what's on it but can save to your phone or tablet thru the app before...
Ok I have my phantom up and running after frying my central circuit. But my Taco gimbal is still doing the funky chicken. I've seen the 59 page discussions on this gimbal but haven't found any one with all the steps it seems when I take a little from one person and a little from another the...
Thanks DK.... Wasn't expecting the tape to hold the tight.. got it soldered back and just about done I removed one cable before I thought about taking photos.. So if any one has a good pic of the M1-F2 side id be in your debt.. Hope to be up and filming if the weather breaks today, just...
I just received a new central circuit, after frying it by unplugging the camera with the quad powered up. I have the board out but cant figure how to remove the Main controller. Is it soldered on or is can I just pry.. Any help on this rainy day would be greatly appreciated.
No responses yet my luck. So I took the main control board out today and removed the two capacitors the tested out good not much more on the main board I can test. the unit is still powering on just no power to the camera cable, which I also tested and seems fine.
I installed the taco gimbal, and was trying to fine tune it with all the settings I've read on this site. The gimbal started to jerk and then I lost power all together. When I plug in to the micro usb on the gimbal both the camera and gimbal are powering up. If I plug the white cable in to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.