I'm just curious.
It seems most of the posters here were satisfied with their Phantom 2 using the prior firmware. So, why upgrade to 3.04?
I have not upgraded anything for a few months because I am happy with the way mine performs.
All comments welcome.
Thanks
That may be possible, but what I do is just take off with a slight angle down and leave it there so you won't see the props in your videos. Play around with the tilt lever with the Phantom on the ground in front of you until you have a feeling where 30 deg tilt is on the lever movement. Just...
Group challenges FAA authority to regulate "Drones".
http://www.newsmax.com/scitech/drones-faa-texas-unmanned/2014/04/06/id/563949/
We all have to stand up for our rights and freedoms. Our Government is out of control.
I had same problem. I switched Stick Mode to "Mode 2" in the RC Assistant Software Program then that corrected the problem for me. Look at the sticks (Channel Monitor) and see what happens when you the move them (throttle, etc). Some previous
posts, here or elsewhere, say the mode came...
I just found your post after a search. I have had this problem for weeks and did what you suggested and that did the job.
Thanks so much, and thanks for all the great posts and info on this board.
Just take your wall charger and one of these into the field:
http://www.bhphotovideo.com/c/product/995841-REG/wagan_2003_5_smart_ac_400w_usb.html
That's all you need.
A lot less than the DJI Car Charger. JMO
I know what you mean. My retail supplier agreed to exchange my "bricked" RC. It should be on it's way to me.
I'm very reluctant to attempt the RC upgrade again. I hope it has already been done.
I'll use my Zenmuse the way it is for now, I hope some day DJI will somehow enable upgrades without...
My reseller allowed me to return the remote for exchange. I hope the new unit's firmware is up to date. I'll be somewhat hesitant to try another RC upgrade after the last fail.
If my Zenmuse gimbal performs OK, I'll just leave well enough alone.
Thanks all.
I found two or three other posts in RC Groups Forum of that same thing happening.
One person was able to get power back by removing the batteries and switching on the power for an hour to "clear up" something and seems to have repaired itself. Another person was in the same boat as me.
An...
I added the Zenmuse Gimbal and attempted the upgrade as instructed here:
http://www.dji.com/dji-released-new-firmware-for-phantom-2-remote-control/
I got no further than step 1 (upgrade RC to V1.0.1.11)
A warning came up that said "upgrade failed". The red Power LED on the remote went out and...
I added H3-2D gimbal to my P2, then tried to upgrade RC firmware to V1.0.1.11 with RC Assistant Software. I got a message that the upgrade failed. The RC red power indicator went out when I got the fail notice and now it seems to have no power. I'm stuck. Is there a reset button on the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.