I agree with the above post
I think your low voltage cutoff is set with figures that trigger it to to come on to early. Your short flight only used a small amount of power from the battery hence the short recharging time.
Firstly you need to workout the voltage loss during a flight.This...
Re: Help! "Tx Signal Lost" Light, Tried All the Fixes I Can
When it says throttle switch down , pull it all the way down , ignore the spring setting otherwise you will get a mis-calibration which will give an error.
Re: Help! "Tx Signal Lost" Light, Tried All the Fixes I Can
When you say you have done the tx calibration are you doing it using the s1 and s2 switches and sticks (ie not through the assistant). I'm wondering if your initial problem was the "flyaway problem" associated with earlier firmware...
Re: Help! "Tx Signal Lost" Light, Tried All the Fixes I Can
Hi
If you have upgraded to firmware 4.02 have you downloaded the default parameters from the dji site and installed them ? Also in the assistant have you changed the receiver from ppm to d-bus?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.