Recent content by cyphico

Yes it does with the tool I am using. I just could not copy the entire thing because the terminal closes automaticaly when it finishes. That is the "manual" tool that does'n work at all for me. (Interfacing to the DM36x via UART failed. Please reset or power-cycle the board and try again...)

Yes, but should BT00 and BT01 have a 3.3v signal from the FTDI, or should they just be shorted between each other? Because I may hvae read the instructions wrong and fed them with 3.3v. I might have to look for some other damage then, or simply accept that the board or chip is unrecoverable...

Okay so I tried one more time with the manual mode, and it would not even flash succesfully: And this is what I get with the flashing tool/script. I could not get the last bit because it closes the cmd when it is finished flashing: But even though I desolder the bootloop pins I still get the...

I used a tool from git: Judslat/P3P-Flash-tool Seems to be using cmd if I'm not mistaken. Edit: I can try again when I get home from school and upload some pictures/logs from the process.

Camera controls seem to work fine, except no video feed. I don't understand what I am missing here

Hello! What a great thread with so much great information. Thank you! So I have come to one issue as many others. But I can't find something specific to my situation after reading the entire thread, so I will have do drop a question and hope to god that someone has a solution. I have...