The cell voltage from each cell on my bad battery were pretty similar. Took a picture before i sent it back here was the readings:
Cell #1: 3789
Cell #2: 3782
Cell #3: 3775
Voltage was at 11346 mV and Current was at -1504mA
Any of this sound strange?
I had an issue with one of my batteries swelling up. Would go into low battery mode and start loosing power around 55%. Sent that back to get replaced and now i am looking at my other battery and cant really tell if it is swollen or not. It has a little squish to it but not nearly as bad as my...
I ran into the same problem today! It sucks! Let me know if you come up with a fix. Im going to call dji tomorrow, im sure they will be no help but ill keep you posted if i come up with something
When i had this issue it was because my sd card wasnt a 10 class. I tried formatting it and it worked again but i just went out and bought a better card to make sure it didnt happen again. Especially since i was out in the city for 8 hours filming and didnt realize it was doing this until i got...
When I plug my phantom in i get this "main controller firmware mismatch" warning at the bottom of the screen and it blocks all the tabs out so I cant really click anything. Anyone know what im doing wrong?
I want to adjust the gimbal tilt speed in the advanced setting but cant get to it. I am...
Even in Naza mode i cannot click on anything but upgrade and info. When i try and click anything else such as advanced it just blocks it out and shows that "main controller firmware mismatch, please update your firmware!" notification.
Also just curious if being in NAZA mode will increase the...
When i click the Phantom button on top it bring up a warning asking if I want to go to Naza M working mode. Is this where I need to be for the IOC?
Yeah I watched some videos and read some articles online so I have a pretty good understanding on home and course lock, which is the whole reason I...
When I connect to the P2 assistant it shows that its connected but it says "main controller firmware mismatch, please update your firmware!"
Says that when I try and click on anything. When its connected to the Naza software it doesnt show that the phantom is even connected. All this software...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.