Recent content by cory nigri

  1. C

    Followed all the instructions to fix horizon, does this picture look off?

    I apologize, I was having a VERY bad day!!!!
  2. C

    Followed all the instructions to fix horizon, does this picture look off?

    the aerial quadcopter world is changing dramatically with multiple entries the market. Complaining about slightly tweaked edges in your photo belittles and reduces the revolution to a marginalised uninspired view of the revolution taking place.
  3. C

    Phantom 1 Right front motor brief throttle up before CSC shutdown

    They all start and stop at the same time. Bearing was replaced not motor. Shut down is as per normal with throttle stick full down. When in CSC mode there is a slight brief surge in the motor where the bearing was replaced. Soooo.....not sure if its ECS or not. I am going to do the shielding...
  4. C

    Phantom 1 Right front motor brief throttle up before CSC shutdown

    Yep I have done it that way which shuts down just fine although as designed slower than CSC. Which made me wonder about the ESC or the hand catch/extra stress due to either hand catch or prop strike in the grass.
  5. C

    Phantom 1 Right front motor brief throttle up before CSC shutdown

    I have a new 1.1.1 version which had a bearing replaced in the motor after the motor developed a rumbling sound after a ground prop strike. Replacement went fine all good. Took off prop guards and had a tip over on landing in shortish grass. After that decided to start hand catching on landing...
  6. C

    video of proper motor behavior with motor test in assistant

    Does anyone have video of how the motors behave when being tested with software? I have one that spins more freely when you click the mouse and sounds a little rumbly. A crash was involved earlier. They all spin up fine but I'm concerned somehow the bearing was damaged although there seems to be...
See more