Recent content by CoreyNach

  1. C

    Gimbal failed mid-flight. Any advice before RMA

    Snooze... so sounds like it's normal then.. not a problem?
  2. C

    Gimbal failed mid-flight. Any advice before RMA

    So I haven't tried to reseat, but I did try to take a picture of the (for lack of better word) "split" in the ribbon cable at the end. Here is an unedited picture: See IMG_2198 And here is one I edited to better emphasize the "split"... is this normal? See IMG_2198.Edit
  3. C

    Gimbal failed mid-flight. Any advice before RMA

    I'll be sure to take a pic, but sounds like some ppl recognize what I am describing... Whatever it is, I think it was always there. If it's intended to be, no big, but if it is the ribbon separating, perhaps that is what moisture got into, to cause the problem (this is a pure guess). In any...
  4. C

    Gimbal failed mid-flight. Any advice before RMA

    Thanks for the reply. I immediately visually checked the craft after landing. The ribbon looks ok, I checked it all around the gimbal, just to make sure there were no tears, and I don't see any. There was no obvious sign of mis-alignment, but I did push on it lightly, to be sure it was seated...
  5. C

    Gimbal failed mid-flight. Any advice before RMA

    I'm a P3 Pro owner and very early adopter. I ordered mine directly from DJI 4/8, and got it within a day of all the other first batch orderers in the US. I had Phantoms before (400+ flights on a P1). I haven't flown the P3 too much (only about 30 flight) due to business, but it has been a...