Recent content by ConnorG

These phantoms track GPS, which is based in the US , and GLONASS, which is based in Russia. So you get great satellite reception all the time. Having GLONASS basically doubles the amount of satellites your device is capable of connecting with. There is also Beiduo run by the Chinese and Galileo...

why?

I'm running a new Asus Zenbook Pro UX-501 Core i7 6700K skylake quadcore 16gb of DDR4 memory Nvidia GeForce GTX960M 2gb GDDR5 512gb 512GB PCIe G3x4 SSD (this is basically a Samsung 950 pro drive and its fast) 4K ips screen with touchscreen All aluminum body $1500 on amazon.. this is...

I'm calling DJI tomorrow or someone that can give some over the phone advice from a place that sells these things

I've done that already. With the old board the LED was red and would not do anything. Rebinding did nothing as well. I replaced the receiver board and did the entire rebinding process multiple times. The LED responds to the transmitter being turned on and off but still the P2 is not getting...

Yes all the stick values are in at 1000. I've tried multiple times plugging the controller in the RC12 program and recalibrating and going back to phantom assistant but nothing has changed. here are my IMU values I've also reset the Naza unit and reloaded firmware and that has not changed...

Sent you a message

Central Alabama

Yes the controller is on when I was trying to calibrate with the P2 software. In the software I watched for the needles to move showing that the P2 is getting a signal and it did nothing. The needles just stay to one side. At the bottom of the window is says MODE: FAILSAFE. If that sheds some...

Done exactly what you just said with the linking. Pushed until it flashes red. It blinks red twice then solid green. still flashing yellow and the motors won't start. I just recalibrated the sticks in RC and I cannot calibrate the sticks on the phantom 2 assistant software. Like its not...

I've got a solid green light so it must be connected to the controller. I followed the steps in the manual and got the same result. I'm kind of lost on what to try next.

Still can't figure out what's wrong with the receiving and transmitting. I'm not totally sure if I've done the binding correctly or not.. The receiver light responds to the transmitter being turned on and off but that is all it does.. Attached a link of a video I made to show what its doing.

OK got my receiver board and got it installed. The light on the receiver board is now green. It switches from green to red when I turn the controller on and off. but the phantom still has a fast yellow flash. When I connect the phantom to the assistant software its not showing any input from...

Changed out the gps antenna module and still no luck. My new receiver board should be here in a early next week. I'm hoping that will fix it

I was very sure these got plugged in as I found them so I wouldn't think these would be swapped around