Hi all I have abit of a weird one here replaced all 4 motors on my p3s that’s fine however on one of the motors I tried to snip the wires on the old motor and the new one and tried so solder the old wires to the new ones so that I wouldn’t have to soldier onto the main board that didn’t work...
OK thanks for that I have also noticed that one of the motors shaft that you screw the props on is shaking slightly I don’t know if it because it’s spinning slightly slower but I do know that when I speed it up it goes away put then as soon as j bring it back to idle it starts again
I would just like to add that I didnt touch anything that the motor sits upon after reading my last message it sounds like I said I did I meant I only did the area beneath the bosses the motors are sitting on the bosses I would also like to mention that I did have the drone flying after I...
Yes I opened the shell and removed all 4 motors after removing motors I poured some epoxy into the area beneath the bosses which the motor sits on then after doing this under the 4 motors I appleied some epoxy on the stress cracks which where on the bottom shell beneath the motors
Ye I also know a friend who did this but I would just like to clarify that I haven’t I was just wondering weather the original screws all tighten up at different levels and if a high pitch noise coming from the drone was normal or not the noise only started this evening
Hi I’m after reinforceing my phantom 3 standard frame from the inside after finding stress cracks that was fine but when I tried to put the motor screws back in I noticed that they all tightened at different levels I never paid attention to it when I was un screwing the screws so I’m wondering...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.