Recent content by Cid

it isnt weight for the quad that is the issue (the whole thing weighs in at less than 8 grams which on a 1200gram quad isnt going to affect flight time. the weight issue was in terms of the lenses themselves and balancing the gimbal motors not the weight of the mounting kit. if you only have...

i also have that same mounting kit and same lens hood for my p2v (non plus) and love it. the lens mounting kit fits perfectly and is very high quality for the cost. the hood is a bit on the heavy side (once i add in my NDF or CPL plus the hood, it is hard to get the rotorpixel to balance rear...

similar to cyclone... the very first compass calibration i did after 3.12 i got a red flashing fail. i power cycled it and recalibrated and it worked fine since then. ive had 3 or 4 flights since then but since i do not calibrate my compass for each flight (only with software updates or other...

Re: Rotor Pixel Gimbal not working after Firmware Update 3.1 i have a RP and i am on 3.12 and do not have this problem

rotorpixel doesnt speak about fpv per se but their website faq specifically calls out interference with the vision wifi signal so i would imagine that would imply there is potential to interfere with your fpv also? you may have already seen this on their site but just thinking it seems to be an...

like many others, i had the same problem after installing my rotorpixel on my vision2 nonplus. i wanted additional takeoff and landing clearance but didnt want to lose the ability for my two existing cases (one hard and one soft, but both requiring original landing skids). here is what i came...