Recent content by chensy

  1. C

    Cannot power up motors

    Ok I think the problem is solved. I must have missed a step when I was following this firmware note: 1)Use the PHANTOM RC Assistant software to upgrade the remote controller firmware to V1.0.1.11. 2)Calibrate the sticks and X1 channel of the remote controller using the PHANTOM RC Assistant...
  2. C

    Cannot power up motors

    Ok I just tried that but it seems the values are still about the same as before when viewed using the P2 Assistant; however, when I look at the values in the RC Assistant, they are -1000 for A, E, and T and 1000 for R...
  3. C

    Cannot power up motors

    Ok, do I do this via the RC Assistant, or P2 Assistant?
  4. C

    Cannot power up motors

    If by fully down you mean towards the right and left corners A is about 180, E is about 390, T is about -330, while R is 647. If you mean just straight down, A is 0, E is about 400, T is about -260, while R is 0.
  5. C

    Cannot power up motors

    Yes I think I have done those.
  6. C

    Cannot power up motors

    I have a P2 and H3-2D set-up. After upgrading all firmware, I can no longer power up the motors using the default CSC. I read somewhere about needing to upload the default configuration parameters and recalibrating the controller -- I think I know how to do the latter but how does one do the...