Recent content by Chengdu Rafael

using on iphone, it only shows images but not the low res video in the DJI Go app... cant find a way to sync videos taken with Litchi to the iphone right after the flight...

What does the app show as status in the top middle bar? Is it connected and ready to fly in FPV mode? I normally send it up in FPV mode and once controlling the aircraft change to Waypoint mode, set/choose mission and press play.

Today I went to fly at a safe location with absolutely no interference, an island with lawn and park all around. Tried a different battery and did both IMU/compass calibration first. Now after few minutes again got the compass error / exit GPS-P warning. Luckily it happened while flying very...

I found there is a 132/10 kV substation within 500 meters... that could have been the cause. Hope it will not happen again especially close to trees/buildings. QUOTE="alokbhargava, post: 948567, member: 38561"]Phantom changes to ATTI mode on its own only when it sees low number of satellites...

A more important question would be: in such situation, what is the right thing to do? Exit GPS-P Mode or not? Switching to A means gaining back control? What made it scary was not knowing the best option. Thanks~!!

Thanks, I will choose a good location with the other battery and flat surface to calibrate both IMU and compass. I hope battery does not cause loss of control mid-flight though. I think for the gimbal the grass was the issue, as I was taking off from grass.

Thanks! i was taking of from grass so it explains the gimbal overload error... As I see in the log GPS signal and compass show just fine throughout the flight, the only thing odd is seen from Notifications : Flight time Altitude Home Distance Type Notification A 00m 00s 0.0 ft 0 ft Mode Mode...

I just had a scary flight and would like to ask for help. this is near the 100th flight on my Phantom 3 Pro but first time in Budapest. Right before taking off an error `gimbal engine overload' showed up, which disappeared after moving the drone and compass calibration. Never had this message...