Recent content by cgy999

Thanks for the suggestion. Yes I have done that. What it does is change the horizon in the camera but does nothing for how far the motor will move.

I'm pretty sure there are not any screws to adjust. This is a different roll motor (likely used) that was put on as a replacement. Do any P4 owners have comments on whether there is a way to adjust these?

I have done all the calibrations many times. What it seems like is when the camera is level that the roll motor is turned most of the way to one end of it's travel. I was experimenting again this morning after doing calibrations and I can roll the drone about 45 degrees left (left down) before...

I have a Phantom 4 which had gimbal damage awhile back and ended up having the roll motor replaced. Since then I have a couple of symptoms that I can't get to the bottom of. On startup I need to hold the camera in position until it starts moving around or often it will end up hanging limp...