Recent content by ceeejay

  1. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Andrew, i already tried it with the files, like i wrote. and i always get the same failure, like i wrote. I don't have other files so i tried to get them from you. I already asked you a few times how to do it with the air unit but your answer is only "same as for ground". This answer doesn't...
  2. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Andrew, would you be so kind and give me your ubl files for the air unit? Thanks Chris
  3. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Ok i don't have a working lightbridge and to be honest, i don't know what you mean with all that "linux stuff" etc. and how to extract the files, like i said i am no programmer :( sorry
  4. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    ok and where should i take the ubl from? sorry but i'm no programmer
  5. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Of course i will prepare a Picture. I welded now a wire to the 3v3 pin on the other side and got an effort. The 3,3V pin directly near the bootsel pin wasn't suitable. Now i got that message repeating until i cancel Operation
  6. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Ok guys, i connected everything like on the ground Station, bootloader-3.3v, tx, rx, gnd, but i still get the same failure: No valid Boot Image found NAND Boot failed Aborting...
  7. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Ok, but why do i get "no valid boot image found" in the console (you can see it in the image above)? Do i have also to connect 3v3-bsel pins on the air unit? or where is the failure? I connected the gnd, tx and the rx pins with my ttl-usb converter and run the console same as for the ground...
  8. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    Hi everyone, Andrew wrote a few days ago: procedure for flashing air unit same as ground I don't know what he exactly means. Can we also use the "ground Images" by Gaucho? Do we have also to connect pins like the 3v3 - bsel like on the ground Station and where they are connected? Unfortunately...
  9. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    So, i found the Pins. Unfortunately i remarked that (of course) the Images for the ground Station are diffrent as for the air unit. How can i create an Image to use? Or where can i get it from? Cheers Chris
  10. C

    lightbridge firmware PROBLEM (and solution) - firmware version not found by dji assistant tool

    First of all, thank you very much Gaucho! My Groundstation is working now. But my Airunit has the same issue and i can't find the Pins. Can you take a look? Front by ceeejay posted Sep 20, 2016 at 9:01 PM Mid by ceeejay posted Sep 20, 2016 at 9:01 PM Back by ceeejay posted Sep 20, 2016 at 9:01 PM
  11. Front

    Front

    Front
  12. Mid

    Mid

    Mid
  13. Back

    Back

    Backside