Recent content by cdsinuk

yes its been a bit frustrating, I haven't exactly crashed and caused damage, but i'm on my 3rd set of props because it falls over on landing GGGrrrr, have tried the wider skids, have tried retracts and every time on landing over it goes, more bent props , have now retro fitted home made long...

Thanks Guys, feeling a bit stupid, didn't realise you only need to hold down the power lever to stop motors, always thought it was both, much appreciated :)

Hi all, my quad keeps tipping over on landing, I am landing as gently as I can, but when I try and cut the motors the quad seems to want to topple over damaging the props, would you recommend I change the motor cut off in naza software from intelligent to immediate??? or is it maybe something...

Hi that's how I made my mistake, I think I had been looking at this model for a while and made assumption it was 2.4ghz, its only when I fitted the tilt control lever that I noticed the label on the back of the control unit and it said 5.8ghz.....

Hi thanks for your help, my quad is a phantom vers 1,1 not FC40 , brought from Buzzflyer the transmitter is 5.8ghz , http://www.buzzflyer.co.uk/DJI-Innovati ... -182-2338/ was looking at GoPro, but made a mistake and have purchased 5.8ghz transmitter and receiver for fpv SkyZone 5.8Ghz 200mw...

hI , I Have DJI Phantom 1.1 , the transmitter is 5.8 ghz, I was looking to put on a FPV transmitter and receiver, but the one I have is also 5.8GHZ, is this likely to cause serious interference to the Quads controller? I know usually if one is 5,8 ghz the other should be 2.4 ghz.. ? so they...

thanks very much :)

hi i've been told you can get ground interference , i've had exactly the same problems in my garden, I have been told to take it to at least 20 ft and let it settle for a moment,

hi syotr... do you know what the voltage is of these wires please, I am going to fit a fpv transmitter and hopefully I can use this spare cable for the power supply ?

just my opinion, I do calibration every time I fly, even if in the same location..... just to be sure :)

thanks very much, I didn't see any difference either , but you know how these things can go wrong very quickly :) thought I would check and see if anyone else had any problems , thanks for the reply, regards Chris :)

Hi , I have recently fitted retracable landing skids on my phantom 1, I have had to remove the original landing gear which housed the compass and the two aerials, I have cut and shortened one leg to re fit the compass, Is there any reason why the aerials need to be fixed to anything or can I...