Recent content by cbpagent72

I have my Hakko set at 450 degrees Celsius. I have been taught to set the soldering iron to the hottest temp that way you don't have to leave the hot to on the circuit board for as long. Sent from my SPH-L720 using Tapatalk 2

FAA doesn't give verbal warnings only in warnings in writing. It is an accountability and records issue. It is very unlikely that the FAA would make a warning via the telephone as opposed to a written warning. If they ever tried to prosecute you for a telephone warning the AUSA (assistant...

Don't waste money on carbon props for quite some time just sticek replacement props. Don't attempt manual mode, I did and it did a flip and crashed within about 10 seconds..lol. Sent from my SPH-L720 using Tapatalk 2

FAA out of Scottsdale, AZ? I am betting that their only office is in Phoenix not Scottsdale. Sent from my SPH-L720 using Tapatalk 2

I can tell you that you were not 600-700 ft up. It may seem that high but in relation to the size of trees and how quickly it hit the ground it tells me that you were maybe 300ft. Just remember the fisheye lens on the gopro makes it look like you are 2 to 3 times higher when you remove the...

Yeah, I think it must have been a typo. Surely nobody would brag about breaking the FAA laws in a metropolitan area with a large amount of air traffic. Sent from my SPH-L720 using Tapatalk 2

The high mod can be corrected by degaussing with a magnet. Just run the magnet around the compass on the leg and you will watch your mod go to normal ranges. Sent from my SPH-L720 using Tapatalk 2

I am running the 14SG and it really works well. Sent from my SPH-L720 using Tapatalk 2

Re: Why don't we start "location" meets so that fellow DJI f I am in Tucson, AZ. Sent from my SPH-L720 using Tapatalk 2

I bought the Pro adrenalin and I am not happy with the quality after the software effects are applied. Sent from my SPH-L720 using Tapatalk 2

The wire length is different for the red esc and green esc. You're pretty much stuck wherever they are. Sent from my SPH-L720 using Tapatalk 2

I am having issues as well, I tried to import the default settings but the NAZA assistant gives me a popup showing that the default config is invalid.

Found the issue, after installing four new motors the noise is gone. It is that great DJI quality control. Sent from my SPH-L900 using Tapatalk 2

The props are on solid and on the right way, I wonder if the heat from soldering damaged one or more esc. The flight characteristics just are not right. Did you adjust any gain settings in naza? Sent from my SPH-L900 using Tapatalk 2

I am not having great results with the T-motor 2216 upgrade, details here: viewtopic.php?f=4&t=1319