Went flying, course lock is working although the Naza light on my smart phone isn't on? Flew great, now the camera doesn't respond to tilt commands. Going back to assistant to recalibrate gimbal. Recalibration of IMU made an improvement in control. This time out I was able to easily land on a...
Tried repowering, what I see now is, the S2 bar in assist shows the switch position in blue for 4 seconds then goes grey again. If I move the S2 to CL and restart that also shows in blue for 4 seconds and goes grey again. So I have to assume the assist is seeing the phantom, for at least 4...
Open Phantom assist on your computer, connect usb cable from computer to phantom and power on. Select tools in the assist program. You should now be on the IMU calibration page. Wait for a status ready to appear then click "check IMU status," it will tell you if calibration is needed, and walk...
In the vision app with Naza selected I check the IOC box but my S2 switch fails to activate the CL and HL modes. It was working earlier. No crashes or hard landings. I have a red/orange triangle flashing in the lower right corner of the app. I clicked on it but it doesn't do anything although it...
While performing advanced calibration of IMU, I get a message that the MC is to hot and to power off for 5 minutes to let it cool. I suspect this message is false as the calibration has only run a few minutes but then the controller started blinking red and beeping, so I switched everything off...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.