Recent content by bzpop

I have GP4 on H3-3D gimbal, i fire it up, all is good, i have picture on my monitor, 4K 30, as soon as i start record picture on monitor gets frozen, record stops and camera goes to 'busy' mode, this setup used to work well, i have fast card, Boscam TS832, i even replaced USB ribbon cable -...

No clue, mine doesnt work properly either way, getting terrible phase scan on Boscam 832, but there are no changes in the noise pattern if i kep the antenna straight or bend it :)

they all not too complicated, but i think it's a good idea to start from the regular setup - transmitter on Phantom, receiver/monitor on the ground, i have boscam 5,8Ghz system RX LCD-5802 and TS 832 , some get better results with TS 353, but if you're not after long range and 6-7 hundred meters...

:) i don't draw any conclusions, i am trying to make this setup work, and greatfull to all who's trying to help, thx!

no, i am sure, it was sealed when i got it, and i don't know a lot about wireless viddeo, but i know you shouldn't power Tx without antenna attached; could it be connection problem, not 'clean' soldering? well, i ordered antennas, and i will re-solder video connections, so far not usable :)...

nothing helps to get at least decent picture, interference is so bad i can't see anything on the screen even when PH2 is 30 feet away, when it's further - more static and scan phasing, the only thing i haven't tried yet is to swap antennas, but if this setup is not defective, and with original...

thanks guys, will try all of the above :))

just got installed TS832 on PH2, paired it with RX-LCD5802, tried all 32 chanels on Divercity, RF1 and RF2, crazy colors, terrible scan phasing and static; is mine set defective and i should try to replace the it, or this is normal? thx!

there is an interference filter board that comes with the H3-3D, do you have it installed? just checkin

It wasn't clear what this part is for, and i thought it is optional, for may be some POV camera connections or something else, so i just put it back into the box and forget about it, then **** start to happen to my setup, video was shaky and the phantom was really drifty, i even went to the...

i hope so too:) i just ordered the same combo, mostly because of the small size of the transmitter, AND your comment :) i don't need 1Km, probably 200-300meters, how do you install this? do i need a hub, do i cut my PH2 open? thx!

lucky you, mine is ****, and no one knows how to fix it :)

that was the first thing i did after i mounted H33D, now to add to this level problem this thing shakes like i don't know what, cheap G3 was better than this,

have the same problem, never had nothing like this even with POS G3 gimbal, it was shaking the camera sometimes, once, or twice, but this is really bad, i can't use the video with this, how to fix this?

got new H33D yesterday - same issue, horizon level is off, could calibration help? thx!