Recent content by Bruce P

I bought a new set of genuine props and I’m amazed at how it flys now.

Anyone have a trustworthy site in the USA to order authentic P3P propellers. I don’t trust eBay anymore since 3D printing.

I did not do a IMU calibration I thought I did but it was a gps calibration.I am using cheap propellers from eBay which is causing the unstable flight.

After powering up the A/C w/o props ,I tilt it forward and back then set it down..The motors are still thinking it’s off level . I can move the throttle and is slow to respond .I did a IMU calibrate still the same issue. I tried with props on and it just to unstable it just flipped and motor...

Anyone know where to find old P3P firmwhere for the remote. Dji site only shows current updates.

Thank you for your help so far . I can not find older versions on the firmware needed to start the update process. The DJI web page only has the newer firmware as an option.

On the remote it has v1.2.6+ and it doesn't have the update button in the app.

what firmware did you update to and where did you find it?

I can’t find the remote software on the DJI site can you send me a link .

I bought the new 300a video board and it connects . now it says to update controller to Inspire-1 v1.3.20

Thank you for your help . I’ll buy one and swap it out .

Ok , can you send me a link .

Do I replace it with the HDMI board ?

Also if the RC boards are very different, will it bind with AC?

No I just replaced it with the same video board. I didn’t know there was different vid board. Which board do I need ?