Recent content by Breaktidemedia

  1. B

    FPV stopped working (not crashed)

    Not receiving and iosd or display at all same as before. The new transmitter instantly fixed the problem so I guess im not understanding how the ribbon cable is the issue if a simple swap temporarily fixed it. I havent checked the anti interferance board but I will take it all apart and switch...
  2. B

    FPV stopped working (not crashed)

    So I recieved my new transmitter and swapped it with my old one. Worked no problem for a couple flights. I turn it on the next day for another flight and it works perfetly then all of a suddenthe fpv shows static just like it did before. This time i watched it happen. any thoughts? I know if i...
  3. B

    FPV stopped working (not crashed)

    Yeah no problems with the monitor working, its so confusing because everything seems to be in working order and plugged in properly yet no reception. It may just turn out to be something small and stupid but I suppose we will find out when the parts come in.
  4. B

    FPV stopped working (not crashed)

    Its the stock one right outta the box. Male antenna to the TX and females on the BP. I was going to upgrade antennas to the spironets but I didnt realize I only ordered two males instead of one of each. I suppose I'll order another TX and see what happens when I swap them. If you think of...
  5. B

    FPV stopped working (not crashed)

    So should I just order another Transmitter and see what happens with that? Serious altitude you got there by the way.
  6. B

    FPV stopped working (not crashed)

    Its getting power for sure. The red light on the transmitter is even turning on and is getting hot lot it normally was. The Its the immersion stock antenna.. I have some fatshark spironets but i havet used them yet.
  7. B

    FPV stopped working (not crashed)

    No telemetry just a black and white static. I dont recall removing the antenna, it was a simple battery switch then it stopped receiving a signal. My shell is open and everything is connected... I attached a top view of my setup and the transmitter that I took off of its external mounting spot...
  8. B

    FPV stopped working (not crashed)

    So I went into the monitor setting and checked they are all at F and channel 1. MODE: DIV BAND: F CH: 1 MODE: Rx1 Rx1 BAND: F CH: 1 Rx2 BAND: F CH: 1 MODE: Rx2 Rx1 BAND: F CH: 1 Rx2 BAND: F CH: 1 All seems to be in order but still only getting static.
  9. B

    FPV stopped working (not crashed)

    Hey guys, So I was flying all weekend covering the desert 100 bike race and the day before the race my FPV stopped working out of no where, didn't crash or anything. I opened her up and made sure it was dust free and all cables were in tack. Everything looks as it did when I set it up and had...