Recent content by Bog

  1. B

    Sweet note from a neighbor

    Awesome story
  2. B

    TX won't connect, yellow blinking LED, solid red RX LED

    If had same..it is the Rx
  3. B

    GPS tracker - RF-V16

    Hay emoney where did you get your skin?
  4. B

    Motors power up fine, but P2 won't take off!

    Jason , in the picture above are the markings on the picture the correct pattern? Is there a document that demonstrates how the wires should layout from naza to all components
  5. B

    TX won't connect, yellow blinking LED, solid red RX LED

    Yes, have to find the diagram to which wire goes where to verify if they all went back properly. Thanks
  6. B

    Motors power up fine, but P2 won't take off!

    Did you connect back with software and verify the mode your tx is in? Mine did the same after a Cali...connect again and verify by the phantom and the tx
  7. B

    TX won't connect, yellow blinking LED, solid red RX LED

    Ok another Canuck here however by reading what Jason has placed on the table. He sounds like a cool guy helping you out. If you have a buddy than why ask a question with a question......come on...I am sure you are a great flyer looking for more answers just like all of us. However here is...
  8. B

    Can't Connect Phantom 2 Assistant via USB

    I ran into the same thing...change cables..for some reason my cable stopped working.
  9. B

    Erratic flying

    Make sure that the rc is calibrated in the correct mode. I have the older controller with the pitch lever in the back and it happens once in awhile after calibrating that is saves in mode 1. Mode one has throttle on the right lever controls , mode two has the throttle on the left lever.
  10. B

    Phantom 2 won't lift off the ground

    i have the the same problem tonight , it happened to me tonight , what was your solution