Recent content by BluWater

I'm also having a hard time getting a smooth transition on the x1 even after the RC assistant software update and Naza software updates. When I plugged in the transmitter via USB to the RC assistant software, it registers the whole range (-1000 to 1000). But when I calibrate x1 using Naza...

I was able to upgrade the DJ6 using the RC assistant. I also upgraded everything else in the Naza software. The x1 is able to register in the software and was able to move the gimbal. However, I just have to fine tune the x1 calibration. Thank you for the tip and possibly spending more than...

That is awesome! I will try it as soon as I get home. Both the local retailer and DJI tech support were dumbfounded of the transmitter issue. They both thought I just have a defective x1 pot. Thank you for your help!

I have the same problem. I have 2 fresh batts and the red light comes on every time during power up cycle of the phantom. I connected it to Naza software and it gave me a low voltage [4] message. I tried different voltage values for the voltage protection and I got no luck. It was still pulsing...

I have the same problem. I have a Phantom 1 (ver.1.1.1) with DJ6 controller. I installed the upgrade board together with the Zenmuse H3-2D gimbal. DJ6 Transmitter does not control gimbal tilt. No X1 input on the software. We tried pairing the Phantom 1 with the older transmitters (the ones that...