Recent content by blueskycam

  1. B

    Video Not Supported - Phantom 2 Vision

    I bought a sandisk wireless thumbdrive with the built in WIFI. It has a slot to accept the Micro SD card. I can network my Ipad and watch the video and images directly. I have had some videos play, then later refuse to play, and some videos refuse to play all together. But when I plug the SD...
  2. B

    Phantom 2 Vision Assistant Software v1.05

    Do I need to update these two first??? 5.8GHz Remote Controller V1.0.2.22 2013-11-05 5.8GHz Receiver V1.0.1.3 2013-11-05 tanx... -slinger i did not touch those. also after you do the first update, you may have to unplug and replug the copter then go on to the auto pilot update.
  3. B

    Invalid Battery on Phantom Vision..Advice needed.

    I should have known better than to do firmware update, i usually wait a while just in case there are problems. Has anybody tried to plug the battery in the charger, to see if the charger recognizes the battery? My battery is full so the charger just shows the green light. the new battery is...
  4. B

    DJI's dirty little secret? Vision video quality

    Have you changed video quality in the camera settings? If that is really a 14MP sensor, a bit of software tweeking ought to bring it up to par. not in the camera, rather in post processing on a desktop or laptop. k
  5. B

    Interchanging blades between the Original Phantom and the Ph

    Re: Interchanging blades between the Original Phantom and th The answer I got form DJI is that the PV2 is heavier and the older blades won't cut it. the motors will be working too hard. I had ordered my PV2 with prop guards, it tuned out that the older guards are smaller than the new props. New...
  6. B

    DJI Phantom 2 Vision Photo quality?

    I am a professional photographer by trade, and just got my PV2 2 days ago. I did the minimal basic preparations and did 2 sorties with the PV2 till the battery ran out. Tonight I finally got to read the manual and calibrate my camera. First make sure the RC is set to FCC rules instead of CE...