Recent content by benbNZ

Man that sucks.... I'm still trying to resolve the issue. On hold to DJi North America now, expensive phone call - hope it works!!!!

Thanks for your reply, I appreciate it. So when doing the firmware reinstall do I have both my controller and aircraft plugged in and powered on? I tried the steps you mentioned but it doesn't seem to work... It still shows that I have no firmware installed for my gimbal and it is still just...

Yep, I haven't actually touched the gimbal since it stopped working. It was during the firmware upgrade that the problem occurred.

Hi, I upgraded the firmware for my Zenmuse Gimbal to v1.8 and followed all the steps in RC Assistant and Phantom 2 Assistant. My PT2 assistant now shows no firmware installed (despite saying it had installed correctly) and now my gimbal is limp and unresponsive. The upgrade fails every time I...

Hi, I upgraded the firmware for my Zenmuse Gimbal to v1.8 and followed all the steps in RC Assistant and Phantom 2 Assistant. My PT2 assistant now shows no firmware installed (despite saying it had installed correctly) and now my gimbal is limp and unresponsive. The upgrade fails every time I...

No luck unfortunately.....

Thank you so much for your reply. So do I uninstall and reinstalls my assistant software and then try calibration? Also, do I have to reinstall my gimbal firmware? My big concern is that in my phantom assistant software it shows that I have no firmware installed on my gimbal... I'll try your...

Hi Guys, I stupidly just upgraded my Zenmuse H3-2D gimbal firmware to v1.8 despite the fact it worked fine and already had the firmware installed (I was just following the instructions after upgrading my RC firmware). I got the message saying the upgrade was successful but now my brand new...

Has anyone found a solution to the gimbal going totally limp after upgrading the firmware? I followed all the steps but now my PT2 assistant shows no firmware installed and it fails every time I try to upgrade the firmware to v1.8. So frustrated! Should've just left it as it was but now I have...