Good Morning Wingnut!! I did get it sorted it out. apparently i recieved a defective ribbon cable. They shipped me a new cable and i behaved correctly. the only problem after that was getting the camera level. It took about 20 times of attempting to align it the motor shaft and control...
I totally agree with your logic, but the sake of america's attention deficit disorder i was trying to be brief and not list every step i performed. I have triple checked all connections, repeated the leveling procedure with no luck.
I was hoping to see if someone had a similar issue and a best...
Last week the kid crashed P2V+ into a tree. this resulted in the ribbon cable to the camera and gimbal motors being severed, and one broken prop.
I just replaced all 4 props and installed a new ribbon cable.
Started up the entire system (the gimbal clamp is not installed) to test the ribbon...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.