Recent content by barnyardflyer

  1. B

    Nvidia Shield recall!

    I just flew my P3A down to 50% and the battery was quite hot to the touch when I removed it as it always is. I wonder if it will be recalled. As long as I have been using LiPos, I have been aware of a risk. Somehow, I think Nvidia is over reacting.
  2. B

    Video: Fitted my Phantom v1 into a Phantom 2 shell (easy!)

    Re: Video: Fitted my Phantom v1 into a Phantom 2 shell (easy Which cable does one use to run 2 batts in parallel? http://www.ebay.com/itm/XT60-Parallel-B ... 3cdd8e1520
  3. B

    Video: Fitted my Phantom v1 into a Phantom 2 shell (easy!)

    Re: Video: Fitted my Phantom v1 into a Phantom 2 shell (easy I just upgraded to P1.5 and I am getting 14 1/2 minutes flight time before the first flash of red in the LED, flying FPV with OSD using 2 Dinogy 2800s in parallel. I am very happy with the results. Thanks for the vid.
  4. B

    Starting stick position does not work sometimes

    OK, I clicked on basic calibration without doing the Check IMU status and all is working fine now. Motors start up normally again. Thanks martinlarosa
  5. B

    Starting stick position does not work sometimes

    I tried to calibrate, but message came back that calibration in not necessary.
  6. B

    Starting stick position does not work sometimes

    Mine is a normal green flash about once per second. When I move the sticks to attempt to start the motors, I get 2 rapid green flashes but no motor start until repeated tries.
  7. B

    Starting stick position does not work sometimes

    I'm having the same problem the last 2 days. I just keep trying and finally the motors will start. I hope someone comes up with an answer.
See more