Recent content by Asparuh Nestorov

I sent it back to DJI. Their support confirm it should not film like that. I will update you when it came back hopefully with some good news.

I just check if the screw is tightened and it seems ok. Also the arm seems well positioned. I do not want to unscrew and re-position is as it is under guarantee and anything could cancel it.

When I loon the clips on my 23" monitor jello is well obvious. The main question now is should I return the copter or try to fight the jello on my own.

I just check the spare ones and they spin the same way. I think the motors are misaligned as well. I will make a video about that. Its interesting that I always catch the drone and its never been crashed / hit ... brand new. However I could not make a flight today as the weather was bad. I also...

Here I cut the most noticeable jello in one clip Nigel thanks for your advice. I looked at your channel and it seems like my jello is way less then your initial jello but more than your jello after the fix. I do not know if I have to send it for repair or I can handle it. I checked the props...

2 pins. Those that were preinstalled.

Hello guys, I bought a phantom 3 standard a week ago but I think I have a jello issue. I updated the firmware, calibrated everything, balanced propellers etc and the jello remains. I have previous experience with DIY 450 quadcopter and cheap (50$) gimbal where I did all the tricks to reduce...