Recent content by Angryhellfire

I still would like to repair my ground units from the p2v+. The RE700 are broken after update via android app. Is there no way to reflash them with openwrt/ddwrt/lucie? I can't be the only affected by this problem here. I found some posts about the same brick but no solution. Thank you in...

Hi Is there a solution for the P2V+ ground unit after firmwareproblem done by DJI? Fabio

Hello Thank you Gaucho for your work. I allready had to reflash many Phantom 2 Vision+ with no image. It worjed always without any problems. Actually I need to get my RE700 working again. Until now 3 pieces are bricked thanks to the app update. Is there a way to flash the wm301_repeater_2g_v1...

Hello I did change the opkg.conf as shomci described and i could finally download luci. Installation etc. everything ok. But when I enable an start uhttpd nothing happens. netstat -pln shows, that port 80 is not working (so no luci in browser...). Someone allready had that problem? At the...

Hello Today a range extender module from a friend got bricked (probably the android apk 1.0.0.60). Is there also a pinout done? Can I readout a working RE and flash the bin/img on the bricked one? Or can I took the bin file on my mobilephone? The bricked RE is no more sending an ssid and the...

Hello You have to change the directory in CMD to the folder where the files are. (put all downloaded files in one folder and navigate before flashing with the command "cd" in cmd console to the filefolder. After that run the command. Example: files are in folder C:\Temp (use easy path on drive...

Hello I would write, that the board needs only 5V connected (first I took a PC Power Supply to get 3.3v, 5v and 12v ;-) ). And "jump" means let it connected when you power on the board. I was a bit confused: jump it when powered on? Let it jumped or just jump and then remove the jumper? Before...

Hello Thank you for your help. Yesterday I could finally get it into "BOOT ME" mode and reflashed it two times. The problem was my adapter. With an FTDI FT232RL it worked without problems. After that everthing was ok and i put it again in the drone. Finally I got my live image back! =D First i...

Hello Thank you for the answer. When I jump "boot" pin with "3V3" pin, nothing happens in the console. Perhaps I do something wrong or my COM adapter wont connect to the board. Angryhellfire PS: I tried it today with a 2nd wifi board. Nearby same text in console. So I think I have to buy a...

Hello Great Tutorial! Thank you very much for your work and sharing! Not many would do that. I also got a Phantom 2 Vision+ and now no more live stream. I tried to follow your tutorial, but my board wont show readable info. I use an normal USB=>COM adapter, could this be the problem? Tried...