Recent content by andrew_by

from which device theese photos?

your problem in a IMG file , you recovered ubl image , but you reflashed IMG file on nand , it is not good because now you need IMG file specially for you module. ill try to help you but i need much more time for this

i reflash this module with img from my attachment and all ok. can you share listing after refalsh , when you desolder BOOTME short

can youy share photo your module that you whant repair.? may be i thnk about any other module

use sfh_DM36x.exe -nandflash -v -p "COMXX" ubl.img u-boot_modifiedByGaucho.img

i all time use ubl image from Lightbridge . because all *.ubl same, only in a few case i use any other ubl for processors with lower frequency for example 297MHZ use attach , in most cases 90% it will work , but if you need ubl_297m.img ubl_432m.img ubl_486m.img ill post them

i flashe same module few minutes ago. all work normally.

Use B_S pin to 3.3V and board will flashed . do not use bt00 bt01 , they fron another proccesor

RX(LB) line not correct soldered..

for the air unit files same as for ground, use Gaucho archives

Hi all! Anyone know about how gps coordiantes in a FLYDAT file? i need this info for my software , tryed to search but nothing. Also can pay for info about gps coordiantes into FLYDAT. thanks.

sory for late message ) but try to flash another UBL . sometime any DJI modules have any other UBL (with different frequency) i have ubl_297m.img ubl_432m.img ubl_486m.img

blue circle on a pic - this is a bootloder pin. connect this pin to 3.3v and you wil see "BOOT ME"

hi guys , yes bootloaders from any dji module same.. of course uImage may different , but it is doesnt matter . just recovery bootloader .. and try start .. or i can send you bootloader speial for air unit .