Recent content by AgentCar

Yes, genuine DJI battery. When the battery would connect properly, everything that I had time to check looked ok. Any ideas on flashing green and red lites and inability to control aircraft?

I received a crashed P3P from a customer. I charged the battery and remote and attempted to fire it up to begin diagnosing problems. As the pictures show, the case is bent, which is the easiest damage to repair. The aircraft sends video, but will occasionally say "Battery Error" which I think...

this is after trying to 3 times to make sure it went through. But it looks like it's skipping it and go to the older version? I don't know. Those numbers just don't look right. Sent from my iPhone using PhantomPilots

I finally got around to trying any of this. This is what my SD card is showing, straight from aircraft, no updates, no downloads. Just pulled it out and plugged into computer. Point is, those numbers don't seem right? Where do I find later firmware versions? I don't even see them listed on DJIs...

They're readily available for the advanced and pro. But somehow the standard got skipped Sent from my iPhone using PhantomPilots

That's correct. After the crash and swapping props I flew the aircraft without any issues, except no video feed. After that, troubleshooting began. I have since opened the shell and all but disassembled to replace the wifi cable. I'm a mechanic, so I naturally don't want to say that the...

I was able to start the motors and fly it with no loss in performance. But now I can't get it to even do that. I'm baffled. Sent from my iPhone using PhantomPilots

No, I'm still working on it. I've replaced the wifi cable (gray 4 or 5 pin connector on top of gimbal) and both antennas. Still no flying. I'm dwindling it down to the board on top of the gimbal that transmits wifi signal. About to buy a used, serviceable camera and try it out. I'll let you know...

I tried relinking remote several times. But the bird shows that it's connected with the green LED? I want to think it's the board on the top of the gimbal that transmits the wifi signal, but that LED shows green also, like there's no issue? I'm trying to find a used, serviceable camera/gimbal...

I've been trying to diagnose my problem after crash for 3 weeks now. I've replaced wifi cable and both antennas after a crash landed me upside down from about 12 feet causing this I have green lights on aircraft, but not on controller. And this is what I get in DJI Go v3.1.5 No firmware...

I have part 97. Already installed. But I'm meaning the board, on top of the gimbal, that the antennas attach too. Sent from my iPhone using PhantomPilots

If it is your wifi module and you find one, could you please post a link? I can't find one for my P3Standard anywhere. Thanks Sent from my iPhone using PhantomPilots

Why can you not buy the wifi video downlink module for the P3S?! I can not find it anywhere, except purchasing a new camera assembly!!! This is the only one I can find. It's for the P34K. Different wire configurations Sent from my iPhone using PhantomPilots

Disassembly isn't bad. Just take your time and label screws. I had to remove my main board, motors, and LED lights to replace wifi cable (wide plug of 6 or so gray wires on camera). Your antennas will be right beside your battery tray. Sent from my iPhone using PhantomPilots

That could prove to be harder than expected. I'm on iOS. I googled to try and find the older file, but it keeps opening up iTunes to the newer version Sent from my iPhone using PhantomPilots