I just installed the 2d....I tied into the main power wires off the battery where it comes into the board..also made the mistake of plugging the zenmuse connector in and burnt up a small chip..it still flies so not sure what it damaged...u can then plug the blue wire from the gimbal harness into...
So while installing the Feiyu tech gimbal the other day I seen a small puff of smoke from the board. Defenatly my fault as I plugged the zenmuse cable into my gimbal which I'm pretty sure caused it..I pulled battery out within a second...after this I installed properly..test flew and everything...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.