Try pressing the small round button on the controller board once or twice to see if it can calibrate the accelerator or gyroscope. Otherwise you may need to run the GUI for tuning. :?: :!: :?:
GUI: SimpleBGC_GUI_2_2b2.zip
http://www.basecamelectronics.com/downloads/8bit/
CP210x USB to UART Bridge VCP Drivers
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx
The controller firmware cannot be upgraded because it is not an official release.
My experience is that the two red LED will not blink when I plug the USB into computer USB port.
They will only blink when I plug into a AC adapter and it will go off in about 3-4 hr after fully charged.
I do not know whether the LED will go off or it get fully charged when it is plugged into a...
I use Tenda A6 router as repeater for my FC40 camera, it roughly doubled the WiFi range from 100M to 200M.
Looking forward to your experience 8-) 8-) 8-)
I just use paper card board to tailor-made a small box for the FC40 to sit inside.
It should be the same for the good luck gimbal, the trick is that you have to shift the FC40 to the side away from the motor to get a balance. :mrgreen: :mrgreen: :mrgreen:
They are bought from a Chinese ebay called taobao.... :P :P :P
Battery : http://item.taobao.com/item.htm?spm=a1z09.5.0.0.jyokp7&id=37675050559&_u=b2ail1m1ff8
Gimbal: http://item.taobao.com/item.htm?spm=a1z09.5.0.0.OZj0Y4&id=22608707024&_u=b2ail1m88d2
I have to turn on the DMZ(De-military Zone) function for the DHCP IP address, e.g. 192.168.2.100 in my Tenda A6 router in order to have the live video FPV from the FC40 camera. Try Try..... :roll: :roll: :roll:
Thank you for showing us the video quality, the 1080p quality is very nice. Also, thanks for the FPV testing of android app, I suppose it is called "Magix". It is a pity that the WiFi connectivity is not comparable to FC40 camera. ;) ;) ;)
http://www.youtube.com/watch?v=9ziblzMVWnw
May I know your comment on the performance of the WiFi Cam?
e.g. video quality, WiFi range, android app as FPV
Any video taken from the camera for viewing please?
;) ;) ;)
I select 2.0A current to charge up to 6 batteries simultaneously and it takes 6 hours to finish & stop itself.
The max current available is 5.0A.
8-) 8-) 8-)
:lol: :lol: :lol:
Go Steadi Gimbal
- weight 140gm
- US$100
2700mah Li-Po Battery US$24
Original FC40 Camera
Total Flight time ~10 min
http://www.youtube.com/watch?v=9ziblzMVWnw
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.