Recent content by 5yoda5

Thank you! Exactly. Correctly. Both versions are suitable for my camera. Therefore, they have one revision number. Here's to compare the photo cable, which is mostly sold everywhere: (not correct for my) Here the points of contact are different from my version. But also sold as a cable for...

Yesterday I completely restored my Phantom. It is a pain.... (in my case) 1. I bought a new top gimbal board. I put it, I did not have any stabilization, the camera did not started completely, but there were weak sounds. 2. After that I ATTENTIVELY looked at the flex ribbon cable. On closer...

If I worked in a repair shop, I would do so. But I repair my own drone and for one repair it is not worth buying it. It's easier for me either to solder the wires, or simply to replace the Nand memory. I may send somewhere "old" chip without reading. Or I may try read it myself. Today I ordered...

Probably i try desolder it and read this as micro SD card. After read i try erase it and solder to back on the board. Picture not actual, just for example.

Ok, i do this. Not reflash. May be it help - i find two old files on flash after update firmware (old files, not now)

That is an empty file with a name "P3S_FW_V01.11.0020.bin"?

It's very sad. For complete of the information I will say that the drone would first be in an crash, the yaw arm was changed and the flexible ribbon cable changed. The picture was, but it was with violet areas. Since go was written "requires an update" I updated: 1. The remote control (normally)...

I read this late, and not save log from video. Ok, now i remove SD card, power on drone, and copy the console. Green led flash (red not flash), camera restart. the video vas finished (i'm very sorry for my bad english):

In the SD card only file "P3S_FW_V01.11.0020.bin" - this is oficial update firmware file. Good, because I'm not ready to change BGA chips yet. Not enough skills now. (but i may try after buy chip and solder mask) If all update correct, when why gymbal not started correctly? Drone was started...

Ok, i correct my mistakes: 1. I connect ODFM board and yaw motor and all gimbal. 2. I take other SD card ("old" was 32 Gb, "new" is 16 Gb), format it to FAT32 and write them firmware. I connect FTDI to U0_T and U0_R (and GND). And power up the drone. I get this messages: ....and again and again...

Thank you very much for the answer. I will try another SD card, but this card work fine on this drone. I'm interested in MC STM32 firmware, which is in the gimbal top board. Today I found a map of the repair on this forum (thank you for this information), now I need to connect the board odfm...

Hello. I have P3A, and top gimbal board not have DaVinchi cheap. I try repair firmware, write BIN to SD card, but it not flashing. In board flashing green led (4 try), red led (4 try), green led never ending. I connect to U0_T U0_R via FTDI adapter and i see this: What format SD card need for...